No more running out of remote control batteries. With this method of the experts you will be able to forget about them.
The remote control is an indispensable object, helping you find your favorite TV channel when you relax on the couch or in bed. However, the stylus batteries of these accessories do not have a long life precisely because they are used a lot. From changing the channel to the volume, then searching for a movie to stream to turning the TV off or on again. Some experts have found solutions so that you don’t have to change your batteries every time.
Can you use a remote control without batteries?
The small domestic accessory for changing channels is always at hand. Many times the batteries run out, so much so that we have to find a solution once and for all. There is no shortage of tutorials on the web that can help in the company, but it is also true that there is some manual dexterity and knowledge of the sector.
Some technicians recommend removing the batteries and opening the internal compartment with a screwdriver. Then you take a power bank and open it, taking inside the battery and its cables. All this to connect the power bank battery with the internal cables of the remote control. A set made of welds and wires that pass through and then integrate the aforementioned battery into the accessory itself.
What do you get? A complete recharge of the accessory that no longer needs to have spare batteries. It is not difficult to put into practice, but in case of doubts or lack of manual dexterity, it is better to contact an expert technician who will know how to act in a few minutes.
Alternative methods when batteries are low
There are also some little tricks that can be applied, in case the battery of the TV remote dies often. The first, which is certainly not a secret, is to invert the batteries: it is a solution that temporarily cushions this need, before changing them definitively.
Other people have thought about using aluminum foil, with a homemade trick to put into practice right away. It is easy to apply, in fact, you just need to take a small piece of silver paper and then apply it directly to the discharged battery.
The flap should be folded three times on itself, then the aluminum foil is placed on the positive pole and not the negative. The foil acts as an energy conductor and gives new life to batteries that will last over time.
If a battery is dead and stores are closed, the screw may be the most ingenious solution at the moment. Take a screw of the same length as the battery used and then make contact at the two ends, as for a battery. With a small commercial set, you can have a new battery for a few days.